Pica 7070 pencil full#

If you do it all, get it all…we offer special pricing on a full set. Furniture and cabinet projects call for either the 24” or 36”. If you make jewelry boxes and smaller scale projects, the 12” is perfect. Your choice in the longer Edge Rules depends on the scale of your work. Woodpeckers Woodworkers Edge Rules are available in 6”, 12”, 24” and 36” lengths. The small size and unique profile make the 6” Edge Rule an ideal pocket rule to keep with you all the time. The 1/32' graduated laser engraved scale is guaranteed accurate to ±. The Edge Rules are anodized for surface protection and to give them our familiar “Woodpeckers Red” color. Both edges are beveled, putting the scale right next to your work, which simplifies marking and minimizes parallax error. This slightly acute angle puts the contact between your workpiece and the Edge Rule at the outside edges which means slight deviations in your workpiece edge won't throw off your measurement. The profiled shape makes it easier to move around on your stock than a thin, flat rule and the beveled edges get the scale right next to your stock where you need it. Mid-Field Measurements Even when you're not working at the edge of your stock, you'll still find the Edge Rule handy. Using the short side of the Edge Rule, you can scribe a line from both sides and the center of the board is between the two lines…it doesn't matter whether your stock is slightly under or slightly over, the center will always be between the lines. As mentioned above, this works just as easily and accurately from right to left as it does from left to right.įinding Center of 3/4” Nominal Stock We all know 3/4' plywood isn't 3/4' anymore, and even if you're careful with your planer, solid stock can be a hair under or a hair over. Marking Edge and Face at the Same Dimension By placing the desired dimension at the end of your board as shown in the photo, you can mark both the face and edge at the same time. Just by flipping the tool over, you can come in from either right or left just as easily. The Edge Rule makes this a simple job, keeping your scale square to your stock and starting flush at the edge.

Measurements from Inside Corners Hardware installation usually calls for a measurement referenced from an intersecting cross-member…like the rails and stiles of a cabinet face frame. Whether you're working on the edge or the face, the corner of the Edge Rule always keeps you properly aligned/ The long side reaches 3/4” across the face of your piece. The short side is just 3/8” wide, giving you plenty of room to mark stock as thin as 7/16”. Woodpeckers new Woodworkers Edge Rule simplifies your life by wrapping around the edge of your stock and giving you an accurate scale on both sides. Woodpeckers ERULE-12 12 Woodworkers Edge Rule